Scientific blog
Archives 

Show All

  • 2015
  • 2014
    • December
    • November
    • October
    • September
    • August
    • July
    • June
    • May
    • April
    • March
    • February
    • January
      • PhD HK
        29/01/14
        My paper entitled „ Tin–zinc alloy electrodeposition from aqueous citrate baths” is already available at http://dx.doi.org/10.1016/j.surfcoat.2013.12.046

        :)

      • QLT MTrybula(January)
        28/01/14
        Thermodynamic description of the liquid metallic solution in the QCA framework. An investigation of relationship between thermodynamic and surface phenomena in liquid binary systems displying negative and positive deviation from Raoult's law. Calculation of fluctuation concentration function a

      • Dezember
        22/01/14
        In December The utilization characteristics to describe the selection of variants of twinning in the magnesium alloy AZ31 . On the basis of orientation maps are currently suitable algorithms that enable the calculation of how much and what share of the twins at the turn of micro-section created by r

      • Singapore brain swept - conference ICBME 2013 A.Mzyk
        20/01/14
        This year I switched from winter freezing in polish cold December reality to egzotic scientific journey to sweaty Singapour. In simple words I participated in the 15th International Conference on Biomedical Engineering (ICBME 2013), where I presented poster entitled “Genipin cross-linked polyelectro

      • PhD report G. Kulesza (December'13)
        15/01/14
        We managed to install in our laboratory interesting device. This device has the ability to test solar cells using photoluminescence and electroluminescence. The first examines the defects in wafers immediately after the texturizing, but with a passivation layer. The second is designed to test cells

      • PhD report December 2013 A.Mzyk
        13/01/14
        I declare to all and sundry that this month I have finished cytotoxicity analysis of the Chi/CS polyelectrolyte coatings. I also performed SEM and TEM analysis of above mentioned films. Of course some of samples were again sent to Laser Center in Leoben because it seems that SiC nanoparticles fabric

      • PhD report A. Mzyk (November 2014)
        13/01/14
        This November was a long month full of cycling through the Leoben in Austria. I spent all my time on practicing tribology measurement methods, samples scratching and PACVD deposition techniques. I have measured mechanical properties of polyelectrolyte coatings based on 24 bilayers of PLL/HA containi

      • PhD report (December 2013) J.Poplewska
        08/01/14
        This month I measured textures for the Al-Zr alloy (for the deformed state and for selected recrystallized states) by X-ray diffractometer. It looks that the recrystallization occurred at room temperature - it will be verified by observations into SEM/EBSD.

        I have started to write an intr

      • December 2013/ Piotr Bobrowski
        08/01/14
        This month I was focused on writing the introductory part of my PhD thesis.

      • December K. Stan-Glowinska
        07/01/14
        This month I was working really hard to finish first version of an introduction to my PhD thesis entitled: “Aluminium alloys based on Al-Mn-Fe system strengthened with quasicrystalline particles – microstructure and properties”.

      • PhD report (December 2013) MG
        07/01/14
        I’ve spent last month trying to prepare first chapters of my doctoral dissertation:

        - “Literature review of development of particle-reinforced aluminium matrix composites (AlMCs)”

        - and “Materials and experimental procedure”.

      • K.Kubok phD report (December 2013)
        05/01/14
        During past month I paid attation more into corrosion experiments - I defined SA/SV - sample area to solution volume ratio. It was done based on literature review as well as data acquired in las months.

      • December report Z.Starowicz
        03/01/14
        In the last last month most of the efforts were focused on photochemical methods and AFM trainigs.
        Photodeposited Ag nanoparticles density and sizes were determined by AgNO3 solution concentration and illumination time respectively. Insteristing results were obtained when laser light intensit

      • J Kawalko December
        03/01/14
        This month I was busy preparing the proposal for grant titled: Evolution of complex loading pre-deformed microstructure and texture of CP titanium during mechanical and thermal treatment, investigated by means of Orientation Microscopy techniques. Should my application prove be successful, I will co

      • December report (K. Glowinski)
        02/01/14
        The newest paper is finally available:
        http://link.springer.com/article/10.100
        Recently I have also started revising my paper on symmetric boundaries.
        Besides, there appeared a paper by Bulatov et al. in which
        a function for calculation of boundary energy based on geometric param

  • 2013
  • 2012
  • 2011
  • 2010