Attempts were made to embossing pattern on a copper disc, completed only a partial success. Due to the high melt of the strong deformation pattern is only partially extruded. However, it was discovered the cause of this difficulty - an outside company doing the matrix does not leave room for the flow of the material during deformation, which is why it has failed to do our prototype in a proper manner. In a further step we modify the template and will attempt embossing pattern. However, two discs prepared with outlines of designs. Since the earlier attempt to create a mirror of the first disk failed, perhaps due to the large curvature of the mirror, or due to a small increase in the electron density caused by insufficiently strong deformation, treated steel segment of curvature smaller ball for the second disc bending previously prepared by careful polishing .