Development of potential parameters to describe the interatomic interactions of liquid aluminium alloys. Fitting those parameters to first principles calculations. Finally, determination of structural and dynamic properties as a function of temperature.

First month of summer time I spent for the LLP-ERASMUS individual training programme internship in the Joanneum Research Forschunsgesellschaft mbH Materials – Institute of Surface Technologies and Photonics Functional Surfaces from 01.06.2014 to 28.06.2014 in Leoben – Austria.
I had an opportunity to get experience and perform experiments on application of the plasma polymerization methods and tribological measurements. I completed the following plan:
1. Familiarization with laboratory equipment and experimental procedures.
2. Preparation of thin films by the plasma polymerization methods.
3. Training in tribological measurements.
4. Micro-mechanical analysis of the polyelectrolyte thin films.
5. Introduction of nano-particles into polyelectrolyte multilayer by plasma polymerization method.

The texture presented in Fig. 2a favours tensile 10-12 twinning during compression along R3 axis (Z axis of the sample). That is because c axes of crystallites lie perpendicular to axis of compression and they are subjected to tension in this deformation mode.
Due to presence of six equivalent {10-12} planes in a hexagonal crystal lattice, grain can undergo twinning in six different ways: {10-12}<-1011>, {01-12}<0-111>, {-1102}<1-101>, {-1012}<10-11>, {0-112}<01-11>, {1-102}<-1101>. The choice of the variant depends on the crystal orientation and direction of the shear stress. The most common model describing the twinning behaviour of Mg alloys is use of Schmid factor (SF) for calculation of grain possible twinning variants. Although there have been reported many deviations from the Schmid law for mechanical twinning, this model seems to be the most appropriate for description of simple {10-12} twinning in Mg.

I started writing a paper on my computer program.
At this stage, it's time to release a version
which could be used by some researchers outside.
However, before this could be done, the software must be
documented, which is a tedious part of work :)

During the last month I was preparing the postconference paper. Since the confrence materials from EMRS 2014 symp. I could be published in journal "Sol-gel science and technlogy" the proposed paper was entitled "Photochemical silver nanoparticles deposition on sol-gel TiO2 for plasmonic properties utilization". Just after the paper submition I was preparing the scientific project proposal to National Center of Science. The project on " The process parameters influence on photochemical deposition of metal nanoparticles on the surface of titanium dioxide on plasmonic properties of obtained nanostructures" which was the continuation of results enclosed within the submitted paper.
Within the experimental part I stated depostion from freshly obtined solution from Institute of Catalysis PAS.